Sometimes the wing nuts need a very slight extra tighten after a few days, if the tank is wobbly. If you get drips from the bolts, take it all apart and put some pipe dope on the bolt threads for the first inch, near and under the bolt head, and a thin layer around the tank holes, above and below.Īnd a thin layer on the metal washer facing up to the lower rubber washer. With a rubber/fiber washer on both sides of the tank bottom holes, the tank is much more likely to stay leak free. Slide up a metal washer onto each bolt, attach wing nuts, and tighten a little bit back and forth, adjusting tank until the tank is level and secure. Getting it wet sometimes helps it stay where it belongs during tank attachment. Then make sure the tank to bowl gasket is in good shape and sitting right. Tighten the nuts snug, but too tight can crack china, or squish the rubber washers too much and they will distort and leak. sponge rubber gasket, and all necessary nut and washers. The RELIABILT universal fit tank to bowl kit Includes : (2) 5/16 in.-18 x 3 in. Lift the tank into place, making sure each of the tank bolts. toilet tank with 2 bolt installation to your toilet bowl with this assembly kit. Then slide up another rubber/fiber washer, then a metal washer, then a hex nut. If you purchased a two-piece toilet, you’ll need to install the tank. The way I would do it is to install a rubber/fiber washer onto the bolts, then slide the bolts down through the tank holes. First, make sure the china near the holes is clean, and no minerals or slime.

Install toilet tank bolts